Chute Assembly - Xerox DOCUPRINT N17 Service Manual

8.3.2 500 Chute Assembly

NOTE: The removal procedure for the 500 Chute Assembly is the same for Feeders 2 and 3.
Removal
1 Remove Feeder 2 (3) ( REP 8.3.1 Feeder 2 and 3 (Optional) ).
2 Remove the Left Cover ( REP 8.3.3 500 Left Cover ).
3 Remove the Right Cover ( REP 8.3.4 500 Right Cover ).
4 Remove the two screws on both sides of the 500 Frame Assembly.
5 Remove the five screws which secure the 500 Chute Assembly to the 500 Frame Assembly from
the top.
6 Position the No Paper Actuator to clear the No Paper Sensor mounted to the 500 Paper Size PWB.
7 Lift off the 500 Chute Assembly.
NOTE: When removing the 500 Chute Assembly, turn and raise the No Paper Actuator in order to clear
the No Paper Sensor mounted on the 500 Paper Size PWB.
Replacement
Perform the removal steps in reverse order.
Xerox DocuPrint N17 Service Manual
SAS485FB
Figure 8.3.2.1 Removing the 500 Chute Assembly
www.printcopy.info
6/98
8-11 500-Sheet Paper Feeder Option