12.3.1 Power Supply
Removal
1. Disconnect the AC Power Cord from the High Capacity Feeder.
2. Remove the four screws that secure the Rear Access Cover. Remove the access cover. (Figure
12.3.1.1)
3. Disconnect the AC power cord from the rear of the Power Supply. (Figure 12.3.1.1)
4. Cut the cable tie that secures the power supply plug to the rear of the feeder drawer. (Figure
12.3.1.1)
5. Disconnect the power supply plug from the Controller PWB.
6. Slide the feeder drawer open.
7. Slide the Power Supply forward until it is free of the mounting bracket. (Figure 12.3.1.1) If necessary,
loosen the nuts that secure the mounting bracket). Remove the Power Supply.
Replacement
1. Perform the removal steps in reverse order
Xerox DocuPrint N17 Service Manual
4
7
Figure 12.3.1.1 Power Supply
www.printcopy.info
6/98
12-11
2
3
rep_01
High Capacity Feeder Option