High Voltage Power Supply (Hvps) - Xerox DOCUPRINT N17 Service Manual

4.12.4 High Voltage Power Supply (HVPS)

Removal
1 Remove the EP Cartridge.
2 Remove the BTR Chute Assembly ( REP 4.7.2 BTR Chute Assembly ).
3 Remove the No Paper Actuator ( REP 4.12.6 No Paper Actuator ).
4 Disconnect P115 and P111 from the HVPS. (See Figure 4.12.4.1.)
5 Use your fingers to open and release the left rear hook securing the HVPS so the PWB floats
from the two bosses.
6 Lift the LVPS up and toward the rear to clear the front tabs, then remove the HVPS.
CAUTION The Earth Spring may fall off simultaneously at this time. Do not lose it.
Replacement
Perform the removal steps in reverse order, ensuring the HVPS is positioned under the retaining tabs.
Xerox DocuPrint N17 Service Manual
Figure 4.12.4.1 HVPS Removal
SAS467F.CDR
6/98
www.printcopy.info
4-59
SAS467F
Repair/Adjustment Procedures