Supporter - Xerox DOCUPRINT N17 Service Manual

4.6.11 Supporter

Removal
1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
2 Raise the Paper Handling Unit Assembly approximately 90 degrees.
3 Remove the wire harnesses connected to the No Toner Sensor and the Registration Sensor
away from the Supporter.
4 Remove the Lever Spring (1).
5 Remove the three screws securing the Supporter to the Registration Plate as well as the screw
securing the Supporter to the Bottom Chute.
6 Use tweezers to release the latch up out of the Front Tray Gear shaft, and pull off the Supporter
along with the Front Tray Gear (2).
CAUTION! The Registration Bushing (3) and the P/Registration Bushing (4) might fall off
simultaneously. Be careful not to lose them.
Repair/Adjustment Procedures
6/98
www.printcopy.info
4-34 Xerox DocuPrint N17 Service Manual