Adjustment
The following procedure is referenced to the rear Elevator Belt. Unless the front Elevator Belt has just
been replaced, access to the rear is easier.
1. Remove the clamp screw and clamp (Figure 12.3.10.2).
2. Loosely reassemble the clamp and move the clamp until the tray measurements front to rear are
equal (+or- 1/16") (Figure 12.3.10.2).
3. Tighten the clamp screw and reassemble the elevator.
Xerox DocuPrint N17 Service Manual
1
Figure 12.3.10.2 Elevator Belt Adjustment
6/98
www.printcopy.info
12-21
2
2
High Capacity Feeder Option
adj_02