Offset Jam/Open Rear Cover (E6) - Xerox DOCUPRINT N17 Service Manual

9.7.2 Offset Jam/Open Rear Cover (E6)

Initial Actions
• Inspect the OCT paper path for torn pieces of paper or other foreign material.
• Inspect the OCT Exit Sensor and Stack Full Sensor Actuators for free movement.
1 Check for rotation of OCT Middle and Exit Roll Assemblies while executing Diagnostic Mode 1,
OCT Motor. The rolls rotate normally.
Y: Go to step 5.
N: Go to step 2.
2 There is +24VDC between P/J210-1 and P/J210-3 and between P/J210-2 and P/J210-4.
Y: Go to RAP 9.7.8 OCT Drive Motor Assembly Failure.
N: Go to step 3.
3 There is +24VDC between J209-9 and J209-10.
Y: Replace the OCT PWB.
N: Go to step 4.
4 There is +24VDC between P/J21-9 and P/J21-10.
Y: Replace the OCT Harness Assembly.
N: Go to RAP 7.4.7 Low Voltage Power Supply (LVPS) Assembly Failure (+24VDC).
5 The OCT Exit Sensor is functioning properly.
NOTE: This can be inspected by performing Diagnostic Mode 1, Sensor Input Test.
Y: Replace the Print Engine Controller.
N: Got to step 6.
6 The voltage between P/J224-9 and P/J224-8 is at the low level when paper is present and at the
high level when paper is not present.
Y: Go to step 7.
N: Go to RAP 9.7.7 OCT Exit Sensor Failure.
7 The voltage between P/J209-12 and P/J209-8 is at the low level when paper is present and at
the high level when paper is not present.
Y: Replace the OCT Harness Assembly.
N: Replace the OCT PWB.
Offset Catch Tray (OCT) Option
6/98
www.printcopy.info
9-32 Xerox DocuPrint N17 Service Manual