Outputs - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
Once you have selected the Walk Test option you want to use:
The top line of the display shows
you how many detectors remain to
be tested. The bottom line of the
display shows a list of all the
detectors ready for testing.
10. Walk round and trigger each
detector. The display shows an "A"
at the end of the line each time a
detector is triggered. If you have
enabled the Chime then every time
you trigger a detector the keypads
and loudspeakers give a double
tone chime.
Note that you cannot test HUA, 24
hour or fire zones.
11. Press if you want to see a list of
the zones that have not yet been
tested:
12. Press  or  to scroll up or down
the list.
13. Press  to end the test.
The control unit leaves walk test
mode and the bottom line of the
display shows the option you were
using.

Outputs

1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
4. Administration


















Page 65