4. Administration
"00:00".
To Program Days Of The Week for Latched Outputs
In addition to specifying an On and Off time during the day for a latched
output, you can also specify which day of the week that the output should
operate on.
First make sure that the output you wish to use is programmed as Latched
= Yes (see steps 1 to 16 starting on page 86). Then make sure that you
have specfied On and Off times (see steps 17 to 24 starting on page 89).
25. Press until the display shows:
26. Press .
The bottom line of the display
shows "Sunday" and "Yes" if the
output will operate on that day, or
"No" if the output will NOT operate
on that day.
27. Press or to change the "Yes"
to a "No" or the "No" to a "Yes". For
example:
28. Press repeatedly to show the
other days of the week, for
example:
29. Press or to change the the
"No" to a "Yes" for each day on
which you want the output to
operate.
Note: If you wish the output to switch on and off at the
same time every day then make sure each day
of the week is set to "Yes".
Page 90
Menvier30/40/100/300