Programming Remote Controls And Two-Way Keyfobs - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
30. Press  when you have finished
making changes.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
31. Press  to leave the menu.
Note: You can switch the output on and off from the Menu by selecting
Outputs On/Off (see page 107).
If you want to program a remote control to control the output, see
page 95.
Programming Remote Controls and Two-Way
Keyfobs
Master users can re-program buttons on an i-fb01, or the "*" button on a
FOB-2W-4B, after the devices have been assigned to a user.
If a Master or Admin user changes the wards assigned to another user,
then the user themselves must change the wards assigned to their own i-
fb01 (see "Programming Set/Unset below) or FOB-2W-4B (see "Re-
assigning FOB-2W-4B Wards" on page 95).
Programming Set/Unset
To program an i-fb01 remote or the FOB-2W-4B "*" button to set or unset:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
Press  until the display shows:
6.
4. Administration














Page 91