Eaton Menvier 20 Administrator's And User Manual page 54

4. Administration
If you are a Normal User, Ward User, or
Easy Set User:
Press .
6.
Press  until the display shows:
7.
Press .
8.
Note: If you already have a prox tag
allocated to you then the screen
will display "Delete Prox Tag?".
See page 52.
9. Hold the prox tag up to the
keypad.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
The control unit has learned the identity
of the tag and linked it with your access
code.
You cannot register more than one tag per user. If you present a tag that
the control unit has already registered to another user then you will hear a
single low tone, the display will show a message that the tag is already in
use and will then revert to asking you to present the tag.
If you do not wish to register a tag for the user then press .
If you have a proximity tag and want to know who it belongs to then use the
Test - Prox Tag menu option, see page 58 .
Remote Controls and Two-way Key Fobs
No user can change any other user's remote control or two-way keyfob. (A
Master User or Admin User can register a remote control or two-way
keyfob for a new user when they first add the user to the system, see page
53.) Any user except a "Guard" or "Set Only" user can register a remote
control or two-way keyfob for themselves as follows:
1. Make sure the display shows the
standby screen.
2. Press .
Page 48
Menvier30/40/100/300








followed by:





