Table of Contents
Advertisement
4. Administration
NOTE: If a warning tone for a ward is due from more than one event at the
same time, and ANY of the tones are set to "Audible", then the tone
will be audible.
Edit Event
Delete Event
Add Exception
Page 78
Event Actions. In a part setting press or to
select one of: Full Set, Part Set B (or C or D) and
Unset.
In a ward based system the keypad display shows a
list of wards. Press or to scroll through each
ward. Press or to select one of the actions: Full
Set, Part Set or Unset. Alternatively, select "No" if
you do not want the ward involved in the event.
Remember that one event in a ward based system
can affect more than one ward.
Event Exceptions. Press or to scroll through
the list of programmed exceptions. Press or to
specify "Yes" (the exception applies to the event) or
"No" (the exception does not apply to the event).
Warning Time. Key in a number of minutes between
1 and 30. The default warning time is 10 minutes.
This time is the duration that the control unit will
sound the warning tone before the start of the event.
Warning Tone. Press or to choose between
Enabled or Disabled. Press to confirm your
choice. When Disabled, the control unit will NOT
sound a warning tone for the event (although the
warning timer will still operate). The factory default is
"Enabled".
This option allows you to edit individual parts of an
event if you need to change one after setting it up.
Use this option to delete an event.
Use this option to create an Exception. During the
time specified by the exception none of the events
linked to the exception will take place. When you add
an exception, the control unit guides you through the
following steps:
Menvier30/40/100/300
Hide quick links:
Advertisement
Table of Contents
