Using A Remote Control - Eaton Menvier 20 Administrator's And User Manual

3. Setting and Unsetting

Using a Remote Control

Setting
Note: You must ask your Administrator to provide a suitably programmed
remote control, see page 91.
Secure all your windows and doors.
Make sure the system is in standby, and that you can hear the warning
tones from the internal sounders.
1. Press the appropriate button on the remote control, either full set (A)
or part set (B) (see Figure 8).
Figure 8. Remote Control Button Functions.
The keypad sounds the exit warning tone.
2. Complete setting using the method programmed by the Installer (see
"3. Finishing Setting" on page 24).
Unsetting
1. Enter by the designated entry door.
2. Press on your remote control.
The system unsets. At this point the system displays the standby screen.
Note: Your administrator may have programmed the control unit so that you
cannot unset the alarm system using a remote control. See page
102. However, if the entry timer has started then you can still use
your remote control to unset the system.
If The System Will Not Set by Remote Control
If one of the detectors is still active when you try to set the system then you
will not hear the exit warning tone. Instead the internal sounder will give a
single beep.
What happens next depends on how the installer has set up your system.
Page 32
Transmit LED
Full Set
Part Set
B
Unset
Menvier30/40/100/300
A
(Programmable)