Allowing A Fob-2W-4B Or 727R To Start A Hua - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
Press .
9.
The display shows:
10. Press . or  until the display
shows:
11. Press 
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
12. Press  repeatedly to leave the
menu.
Once you have carried out this process, then although remote controls can
set the system, none of them can unset the system. To allow remote
controls to unset the system repeat steps 1 to 12, but select "enabled" at
step 10.

Allowing a FOB-2W-4B or 727r to start a HUA

You may wish to allow a user to start a Hold Up Alarm from a 727r remote
control or a FOB-2W-4B two-way fob. The Installer must first program the
control unit to allow this (note that doing so will mean that the system no
longer complies with BS8243 or DD243). Once the Installer has enabled
the feature, you can enable the remote control or FOB-2W-4B as follows:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
Press  until the display shows:
6.
Press .
7.
4. Administration



















Page 103