Menvier30/40/100/300
receiving centre that the test call
arrived. If the call fails the display
will show "Call failed" followed by a
reason.
System Configuration
The System Configuration option allows you to change some parts of the
system to suit your particular needs. If you need more extensive changes
to the operation of the system then you must contact your installer.
Switching the Chime On/Off
The installer may have set up your alarm system to give a chime tone
whenever something triggers one or more detectors while the system is
unset. If you wish to switch this feature off (or on) then:
1.
Make sure the display shows the
standby screen.
2.
Press
.
3.
Key in your access code (or
present a tag).
Press until you see:.
4.
Press .
5.
The bottom line of the display
shows:
Press .
6.
The bottom line of the display
shows the current status of the
Chime facility: "On" means the
loudspeakers will sound a chime
tone every time a detector with the
"Chime" attribute is triggered.
Press .
7.
The status of the Chime facility
changes each time you press .
Press when you have finished
8.
4. Administration
Page 73