Walk Test - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
by its name.
Note that the LEDs around the
navigation key and the four LEDs
at the right should all be glowing
red.
8. Press each key once.
The bottom line of the display
shows the key you pressed.
Press both radio HUD keys
together to test.
As you press the function keys on
the keypad the display shows their
name, for example:
Press  to end the test.
9.

Walk test

The Walk Test menu allows you to test detectors without starting an alarm.
To "walk test" an alarm system you operate each detector in the system. If
the detector is working the control unit sounds a confirmation tone and
flags that the detector has passed the test. Simply walking past motion
detectors should be enough to trigger them, but you will have to open doors
and windows if you want to test any detectors attached to them.
Note that you cannot test wired HUA wired buttons, Fire detectors, and 24
hour zones during a walk test. The control unit will always start an alarm if
you activate those detectors. (A 24-hour zone has detectors that are "live"
all the time, not just when you set the system.)
If you find a detector that does not work, call your installer.
To use the Walk Test menu:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
4. Administration












Page 63