Eaton Menvier 20 Administrator's And User Manual page 98

4. Administration
Press .
7.
Press .
8.
9. EITHER
Press the button on the remote
control that you wish to program.
Hold the button down until you
see the transmit LED flash.
The keypad gives a double
"beep" confirmation tone. The
display shows the identity and
owner of the remote control, and
the button you pressed. Go on to
step 10.
Note: If your system is a part setting
system (there are no wards)
then you cannot reprogram the
unset key on a remote control.
If your system is a ward based
system then the unset button
can only be programmed to
unset all wards allocated to the
user, or unset individual wards
allocated to the user.
OR (if you do not have the remote in
your possession)
a) Press .
The display presents a list of the
registered remote controls and
their users.
Press  or  to show the
b)
remote control you want to edit.
Press  to select it.
c)
Page 92
Menvier30/40/100/300











