Radio Hold Up Alarms - Eaton Menvier 20 Administrator's And User Manual

4. Administration
been programmed.)
The bottom line of the display
shows the function of the button
you pressed and the strength of the
signal received by the system from
the remote. If the signal strength is
less than 4 you should contact your
installer.
a). Press all the other buttons on the
device.
Each time you press a button on
the remote the keypad gives a
double "beep" confirmation tone.
For each button you press you will
see a similar message, for
example:
Note: If you wish to test the Hold Up
Alarm buttons on a FOB-2W-4B
make sure you press them both
at the same time.
b) Press a button on any other device
that you wish to test.
The keypad gives a double "beep"
confirmation tone.
The display shows information for
any device allocated to a user of
the system, for example:
Press  to end the test.
9.

Radio Hold Up Alarms

1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
Page 68
Menvier30/40/100/300










