Eaton Menvier 20 Administrator's And User Manual page 20

1. Introduction
HUA With A Two-Way Key Fob
It is possible to start a Hold Up Alarm from a two-way key fob. However,
the Installer must enable this within the control unit. (Note that doing so will
mean that the system no longer complies with BS8243 or DD243.)
Once the Installer has enabled this feature, a Master User must also turn
this facility on, see page 103.
When the feature is fully enabled, to start a HUA from a Fob-2W-4B:
Press and hold any two diagonally
opposite buttons at the same time.
All four LEDs flash red three times.
The control unit starts a hold up alarm.
If your system is connected to an alarm
receiving centre the control unit sends a
hold up alarm message to them. The
control unit then sends a message to
the fob to confirm that it has started a
hold up alarm.
All four LEDs glow green for three
seconds.
Page 14
Lock
Figure 5. HUA Buttons
Menvier30/40/100/300
HUA