3. Setting and Unsetting
Unsetting the System
Press and
hold:
What Happens if the System Will Not Set
Press and
hold:
Querying the State of the System
Press and
hold:
Page 34
The un-setting LED flashes red three times.
The system unsets.
The unset LED glows green for three
seconds.
The setting LED flashes red three times.
The system tries to set. If there is a fault
(for example a door is open) then the
control unit sends a message to the fob to
say that it cannot set.
All four LEDs glow red for three seconds.
The query LED flashes red three times.
The control unit sends a message to the
fob giving the current state of the system. If
the system is:
Full Set, you see a green Set LED:
Part Set, you see a green Part Set LED:
Unset, you see a green Unset LED:
Menvier30/40/100/300