Alarms; Silencing An Alarm - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300

2. Alarms

The table below shows the different kinds of alarms possible.
Type of
Alarm
Intruder Loud warbling tone
from siren.
Fire Pulsing tone from
sirens, internal
sounders and wired
keypads.
Hold Up Loud warbling tone
from siren
Tamper Loud warbling tone
from siren
Technical Quiet beeping once
per second from
wired keypads.
Fault Quiet beeping once
per second from
wired keypads.

Silencing an Alarm

Signal
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire zone activated at any time.
HUA zone or radio Hold Up Alarm
transmitter activated at any time.
(The installer must enable this feature
on your system.)
Some part of the alarm system has
been opened (tampered with).
An alarm system cable has been cut
or shorted.
An incorrect user code has been
entered too many times.
Technical alarm zone activated at any
time.
(Audible only when system is unset.)
A system fault detected by the control
unit, for example, mains failure, or
communications line fault. See page
19.
Started by:
Pressed on keypad.
Page 15