Eaton Menvier 20 Administrator's And User Manual page 43

Menvier30/40/100/300
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press .
4.
The bottom line of the display
shows the first of a list of zones
that you may omit. (Either as a
zone number or as a name, if the
Installer has programmed one for
the zone.)
Note: If you see the message "No zones
omittable" then the installer has
not programmed the system to
allow you to omit zones.
Press  or  to display the zone
5.
you wish to omit.
Press  to mark the zone for
6.
omission.
The character at the end of the line
changes to an "O" to show that the
zone will be Omitted.
If you change your mind then press
 again so that the end of the line
shows an "I" (for Included).
7. Repeat steps 5 and 6 for any other
zone you wish to omit (or include).
Press  to store the changes you
8.
have made.
The keypad gives a double "beep"
confirmation tone.
4. Administration














Page 37