Technical Alarms - Eaton Menvier 20 Administrator's And User Manual

2 Alarms
seconds, the rim of the navigation pad
will glow green. In addition the keypad
will stop beeping.
OR: Press . The rim of the navigation
pad will stay red and the system will show
the text of the alert the next time you key
in an access code. (The keypad will stop
beeping.)
Note: 1. The system will not alert you to short (less than 10s) interruptions
of mains power. If the cause of an alert goes away, then the system
will remove the Alert message.
2. The system records all alerts in the log, with the time when you
acknowledged them.
To set the system while a fault is present please go to page 27.

Technical Alarms

Your alarm system may be fitted with a "technical alarm" zone. This type of
alarm is NOT designed to alert you of a fire, burglary or personal attack but
can be used, for example, to monitor the temperature of freezers, or the
health of other equipment.
When a technical alarm occurs the control unit makes the rim of the
navigation pad glow red, and the keypad will give a short "beep" every few
seconds, exactly as for an Alert.
You can silence the beeping tone by following steps 1 to 4 on page 19.
When you key in your access code the bottom line of the display will show,
for example "Tech Z020 Alarm" to indicate that the cause of the beeping is
a technical alarm. (Press  or  to see the zone name, if one has been
programmed.)
Note that if the technical zone detector is still active when you try to reset
the system then the keypad will show the message "RESET FAULTS". You
must make sure that the detector is not active before you can reset a
technical alarm.
Page 20
Menvier30/40/100/300