Unsetting The System Using A Keypad - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
Message




or



Unsetting the System Using a Keypad

When unsetting the system do not stray from the entry route designated by
the installer. If you do so then you will cause an alarm.
Start the Entry Procedure
Do this:
1. Enter by the designated entry
door or route. (This usually the
last through which you leave the
premises.)
Go directly to the keypad.
The system starts the entry timer.
The keypad sounds the entry tone
(an interrupted tone).
Identify Yourself
Either key in your access code
2.
As you key in your code the
display shows a "*" for each digit.
OR present your proximity tag
(see page 11).
Meaning
An expander or keypad has
a fault, or the cabling
between parts of the system
has a fault.
The AC supply has stopped
for more than 10 seconds.
The back-up battery has a
problem.
Part of the communication
system has a problem.
The system has
detected a fault not covered
by the above categories.
3. Setting and Unsetting
Override by:
Grade 2
Installer
User
User or
Installer
User or
Installer
User
The display shows:




Grade 3
Installer
User
Installer
Installer
User
Page 29