Eaton Menvier 20 Administrator's And User Manual page 94

4. Administration
again after a set time. You can
program the length of time the
output remains on.
15. Press  or  to select the option
you wish to use.
For example:
16. Press  to confirm your choice.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
To Program Duration Times for non-Latched Outputs
First make sure that the output you wish to use is programmed as
Latched=No (see steps 1 to 16 starting on page 86).
17. Press  until the display shows:
18. Press .
The display shows the length of
time the output will stay turned on
(in seconds).
19. Key in the number of seconds that you
want the output to stay on. The
maximum is 999s.
20. Press .
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
25. Press  to leave the menu.
Note: You can switch the output on and off from the Menu by selecting
Outputs On/Off (see page 107).
If you want to program a remote control to control the output, see
page 95.
To Program On and Off Times for Latched Outputs
Page 88
Menvier30/40/100/300











