Eaton Menvier 20 Administrator's And User Manual page 51

Menvier30/40/100/300
13. Press  to change a "Yes" to a
"No" or back again.
See page 4 for a description of
wards. See Note below for a quick
way of assigning users to wards.
14. Press  when you have finished
assigning the user to their wards.
The keypad gives a double "beep"
confirmation tone.
Note: By default new users belong to all wards. If you wish to delete a User
from all wards then:

a) Press or
the display shows "All Wards" (hint, it's between Ward 1 and Ward 20
on the Menvier300, Ward 1 and Ward 10 on the Menvier100, between
Ward 1 and Ward 5 on the Menvier40, and Ward 1 and Ward 4 on the
Menvier30).
to change the "Yes" to a "No" (or back again).

b) Press

c) Press to confirm your choice.
If you selected No then the control unit removes the user from all
wards. You must select at least one ward. If you press
down you choose individual wards. Alternatively, repeat steps a) to c)
and select Yes so that the control unit assigns the user to all wards.
Access Code
No user can change any other user's access code. (A Master User or
Admin User can create an access code for a new user when they first add
the user to the system, see page 53.) Any user, except a Duress, Guard or
Set Only user, can change their own code as follows:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  .
4.

to scroll through the list of wards until the bottom line of
4. Administration













to scroll
Page 45