Displays - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300

Displays

The LCD display shows messages and prompts to help guide you through
setting, unsetting, resetting and programming the system.
When the system is idle (either while set or
unset) the display shows the "standby
screen", comprising the time and date:
(The top line of the display may show the
installer's name instead of the control unit
name.)
To draw your attention to special events the
rim of the navigation key glows red.
On an i-kp01 there are four LEDs to the right of
the programming keys. These LEDs show the
state of the ABCD keys. When the control unit
is delivered from the factory then:
In a part setting system these LEDs glow to
show you whether the system is set or
unset. The left hand or 'A' LED glows when
the system is full set, the other LEDs glow
when the system is in one of the part set
states.
In a ward based system, the LEDs show
the status of wards 1 to 4.
In a KEY-KX01, KEY-KP01 or KEY-KPZ01 the
LEDs are within the ABCD keys.
(See page 108 to find out what kind of control
unit your system has.)
1. Introduction




Page 7