Other Reasons Why The System May Not Set - Eaton Menvier 20 Administrator's And User Manual

3. Setting and Unsetting
Figure 6. Keypad Display Showing Active Zone
Investigate the zone listed on the display and see if you can rectify the
fault. If your system has been programmed to then you can "omit" the
affected zone beforehand (see page 36 for instructions on how to omit
zones before setting the system). Note that there may be more than one
zone with a fault. The display changes every three seconds to show each
active zone.

Other Reasons Why the System May Not Set

There are several other events that can show fault warnings on the keypad
and prevent your system from setting. Your Installer may have
programmed your system to allow you to override the fault warnings and
continue setting. Alternatively, you may need to call the Installer to rectify
the fault first. In addition, the faults that you are allowed to override in a
Security Grade 2 system may require an Installer's assistance in a Security
Grade 3 system.
The table below shows the keypad message for each fault, what the
message means, and who can override the fault in either a Security Grade
2 or Grade 3 system.
Message


Page 28
SETTING FAULTS
Z041 Back door
Meaning
A Hold Up Alarm device is
still active. (If a user has
forgotten to reset the device
an installer is not required.)
A part of the system has
been tampered with.
Menvier30/40/100/300
Override by:
Grade 2 Grade 3
Installer Installer
Installer Installer