4. Administration
Press to change the state of the
7.
output.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
Note: Outputs connected to radio output
modules may take several seconds to
change state.
Press .
9.
The display returns to the "Outputs
On/Off" menu, and the control unit
operates the selected output.
What System Have I Got?
There may be times, when your installer is helping you with a problem over
the phone, that they ask you what system you have and what software
version it is running. You can find this information as follows.
1.
Make sure the display shows the
standby screen.
2.
Press
.
3.
Key in your access code (or
present a tag).
Press until you see:
4.
Press .
5.
The bottom line of the display
shows the first item in a list of
options that show information about
your system.
Press .
6.
The bottom line of the display
shows your control unit type and its
software revision.
Page 108
Menvier30/40/100/300