Using A Two-Way Key Fob - Eaton Menvier 20 Administrator's And User Manual

Menvier30/40/100/300
a) Try pressing A once more on your remote control. If the installer has
programmed the system to do so then it will carry on and set, omitting
the active detector.
b) If the system will not set on the second press of button A then you will
have to go to the keypad and set the system from there.

Using a Two-Way Key Fob

Note:
1. You must ask your Administrator to provide a suitably
programmed Two-Way Key Fob, see page 12.
2. If your system is certified to BS8243 (ask your Installer) then do
not use a FOB-2W-4B as it will not comply with the entry and exit
requirements. (It could however be used on a compliant system to
unset the system if the building is locked using electronic locks on
the entry doors.)
Setting the System
Press and
hold:
Part Setting the System
Press and
hold:
The setting LED flashes red three times.
The system sets. The control unit sends a
message to the fob.
Note: If the Installer has programmed the
system to complete setting by Lock Set
(see page 26) then you must go to the
designated lock and lock it in order to
complete the setting process.
The setting LED glows green for three
seconds.
The part setting LED flashes red three
times.
The system part sets. The control unit
sends a message to the fob.
The part setting LED glows green for three
seconds.
3. Setting and Unsetting
Page 33