Eaton Menvier 20 Administrator's And User Manual page 30

3. Setting and Unsetting
given the Ward a name, for
example "Stores". this will appear
on the display instead of the ward
number.
Press  or  to select the
e.
change you want for the Ward.
"U>P" = change to Part Set.
"U>S" = change to Full Set.
"S>U" = change to Unset
"P>U" = change to Unset
Note: If a Ward is Full Set then you
cannot go directly to Part Set.
You must unset the Ward first. If
the Ward is Part Set then you
cannot go directly to Full Set.
You must unset the Ward first.
Press .
f.
Go to: 3. Finishing Setting below.
3. Finishing Setting
Depending on how your installer has programmed your system, you will
need to take one of the following actions to complete setting the system.
Note that you will need a special button fitted in order to use Exit Terminate
Set, and a special lock fitted to use Lock Set.
Instant Set:
Note: Make sure you are outside the
protected area before taking the
next step. Instant set does not
have any exit time.
The keypads give a double "beep"
a.
and the system sets immediately.
Timed Exit/Silent Set:
a. The keypad sounds the exit tone
(a continuous tone). The top line
Page 24
Menvier30/40/100/300




↕
