Eaton Menvier 20 Administrator's And User Manual page 72

4. Administration
Press .
5.
The display shows:
Press  until you see:
6.
Press .
7.
The bottom line of the display
shows the first in a list of the
outputs allocated for your use.
If the output has a name
programmed for it, that will appear
on the bottom line instead of the
output number.
Press  or  to display the output
8.
you wish to test.
Press .
a).
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
The control unit turns on the output.
Check that that it is working as
expected.
Note: Outputs connected to radio output
modules may take several
seconds to change state.
Press  again to turn the output
b)
off.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
Press  to end the test.
9.
NOTE: Make sure no one tries to activate an output by means of a remote
control while you perform the test.
Page 66
Menvier30/40/100/300













