Starting A Test Call - Eaton i-on16 Administrator's And User Manual

i-on16
The bottom line of the display
shows the users owning each prox
tag, for example:
If the control unit does not
recognise a prox tag, the display
shows:
Press  to end the test.
9.

Starting a Test Call

If your control unit has a suitable communications module fitted then the
Installer or the Alarm Receiving Centre may ask you to start a test call. This
could be in order to check that the control unit and communications module
are working correctly or to help clear a communications alert. Your control
unit will have two pre-programmed telephone numbers. When the Installer
or ARC ask you to make a test call they will tell you which number to use.
To make a test call:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
The display shows:
Press  until you see:
6.
Press .
7.
The display shows the first of two
telephone numbers that the control
is already programmed to call.
Press  or  to select the phone
8.
number you have been asked to
test.
4. Administration




















Page 61