Table of Contents
Advertisement
01−6
(3)
Never use any electric equipment like an electric motor or a working light as they may cause
spark or high temperature.
(4)
Never use an iron hammer as it may cause spark.
(5)
Dispose the shop lag separately from any fuel deposit.
Clamp Track
1CD−FTV ENGINE REPAIR MANUAL (RM1046E)
INTRODUCTION
11.
(a)
(b)
(c)
D01563
12.
Flat Spring Clamp
(a)
(b)
(c)
(d)
D25081
−
REPAIR INSTRUCTION
REMOVAL AND INSTALLATION OF ENGINE INTAKE
PARTS
If any metal tip is mixed in the inlet pass, that may give a
bad effect to the engine and turbo charger.
When removing and installing of the inlet system parts,
close the opening of the removed inlet system parts and
the engine with a clean shop lag or gum tape.
When installing the inlet system parts, check that there is
no mixing of a metal tip.
HANDLING OF HOSE CLAMPS
Before removing the hose, check the depth of inserting
portion and the clamp position to restore it surely.
Change a deformed or dented into a new one.
In case of reusing the hose, install the clamp on the hose
where it has a clamp track.
For a flat spring type clamp, make it adjust by adding force
to the arrow mark direction after the installation.
Advertisement
Table of Contents
