ENGINE
–
ENGINE MECHANICAL
ENGINE OIL INSPECTION
1. CHECK OIL QUALITY
Check the oil for deterioration, entry of water, dis–
coloring or thinning.
If oil quality is poor, replace the oil.
Oil grade:
API grade SG Energy–Conserving II multigrade
engine oil. Recommended viscosity is as shown,
Drain and refill capacity (2WD):
w/ Oil filter change
4.3 liters (4.5 US qts, 3.8 Imp. qts)
w/o Oil filter change
4.0 liters (4.2 US qts, 3.5 Imp. qts)
Drain and refill capacity (4WD):
w/ Oil filter change
4.5 liters (4.8 US qts. 4.0 Imp. qts)
w/o Oil filter change
4.2 liters (4.4 US qts, 3.7 Imp. qts)
2. CHECK ENGINE OIL LEVEL
The oil level should be between the "L" and "F" marks
on the dipstick.
If low, check for leakage and add oil up to the "F"
mark.
AIR FILTER INSPECTION AND CLEANING
1. REMOVE AIR FILTER
2. INSPECT AND CLEAN AIR FILTER
(a) Visually check that the air filter is not excessively
damaged or only.
HINT: Oiliness may indicate a stuck PCV valve.
If necessary, replace the air filter.
(b) Clean the air filter with compressed air.
First blow from the inside thoroughly, then blow off
the outside of the air filter.
3. REINSTALL AIR FILTER
EG2–13