Pl 8.10 Tray 1-4 & Hcf Feed Assembly - Xerox WorkCentre 4150 Service Manual

PL 8.10 Tray 1-4 & HCF Feed
Assembly
Item Part Description
1 130N01562 HCF tray feed assembly
(4250/4260/4265)
– 130N01559 Tray feed assembly
(4250/4260/4265) (See Note 2)
– 130N01459 Tray feed assembly (4150) (See
Note 2)
2 130N01274 Paper empty sensor (Q07-110
tray1), (Q07-210 tray 2), (Q07-310
tray 3), (Q07-410 tray 4), Stack
height sensor (Q07-150 tray 1),
(Q07-250 tray 2), (Q07-350 tray
3/HCF), (Q07-450 tray 4). (See
Note 2)
3 – Ground strip (P/O
4 – Actuator (P/O PL 8.10 Item
5 – Feed head (P/O PL 8.10 Item
6 – Feed roll shaft (P/O
7 – Bearing (P/O PL 8.10 Item
8 – E-Clip (Not Spared)
9 005N01094 Clutch
10 007N01520 Feed roll gear
11 005N01087 Feed roll drive dog
12 022N02232 Roll assembly (See Note 1 and 2,
Need to order 3 Roll
Assemblies(One roll contained in
each bag))
13 007N01556 Intermediate drive gear
14 007N01522 Nudger roll gear
15 – Harness (P/O PL 8.10 Item
16 009N01594 Spring
17 – Tray up limit switch (P/O
Item 1) (REP 7.2)
NOTE: 1. To reset HFSI count, go to GP 16. 2. Tray 1, REP
7.1. Trays 2, 3 and 4 REP 7.7. HCF REP 7.5. 3. Roll Assy
shipped one Roll per bag. CSE must order three: Nudger
Roll, Feed Roll, and Retard Roll(PL 7.15, Item 20).
Parts List
PL 8.10
PL 8.10 Item 1)
1)
1)
PL 8.10 Item 1)
1)
1)
PL 8.10
January 2016
WorkCentre 4150/4250/4260/4265WorkCentre 4150/4250/4260WorkCentre