Dip Switch Functions - Toshiba e-studio200l Service Handbook

3.12.7

DIP switch functions

You can simulate various functions by setting the DIP switch (SW1) on the finisher controller PC board
appropriately.
Initiating Operations
1) Remove any obstacles from the area of operation.
2) Set the DIP switch (SW1) as shown, and turn ON the power (so that LED1 will start to blink).
3) Press the pushing switch (SW2) twice to initiate the operation in question. (LED2 will remain on dur-
ing operation).
Setting
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Item
Delivery motor The delivery roller rotates in a spe-
cific speed.
Stack processing The stack delivery lever moves to its
motor (stack deliv- home position and stops.
ery lever)
Stack processing The returning roller moves to the
motor (returning home position and stops.
roller)
Front jogging plate When not at the
motor home position
When at the
home position
Rear jogging plate When not at the
motor home position
When at the
home position
Upper stack tray The upper stack tray moves up and
motor (up) stops when the upper stack tray
upper limit sensor turns ON.
Upper stack tray The upper stack tray moves down
motor (down) and stops when the lower stack tray
lower limit sensor turns ON.
Lower stack tray The lower stack tray moves up and
motor (up) stops when the lower stack tray
upper limit sensor is turned ON.
Operation
The front jogging
plate moves to its
home position and
stops.
The front jogging
plate moves over a
specific position
and stops at the
home position.
The rear jogging
plate moves to the
home position and
stops.
The rear jogging
plate moves over a
specific distance
and stops.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
3 - 94
To stop
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Turn OFF the joint
sensor (S4).
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Press SW2 again.
• Turn OFF the joint
sensor (S4).
• Press SW2 again.
• Turn OFF the joint
sensor (S4).