Skew Adjustment - Toshiba e-studio600 Service Manual

3.11.3

Skew adjustment

When an image skew occurs, adjust it according to the following steps, Step 1 Æ Step 2 Æ Step 3.
Note: Note:
Perform this adjustment after confirming that the equipment has been adjusted properly.
Prior to this adjustment, of RADF position and height are needed to be adjusted.
(1) Step 1
Case A:
Shift the screw to an oblong hole, and then move the plate towards the side A to adjust the image
skew.
Case B:
Shift the screw to an oblong hole, and then move the plate towards the side B to adjust the image
skew.
A
Simplex
Fig.3-63
March 2005 © TOSHIBA TEC
Paper
Original
Fig.3-62
Duplex (reverse)
( A )
( B )
3 - 59
White arrow: feeding direction
B
( B )
Fig.3-64
e-STUDIO520/600/720/850 ADJUSTMENT
( A )
3