Adjustment Of Skew - Toshiba e-STUDIO2330C Service Manual

28.5.3

Adjustment of skew

Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying:
(1) Place the chart provided as an original with its face up on the original tray of the RADF, select
[1 Sided -> 1 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the inclination of the copy image.
Duplex copying:
(1) Place the chart provided as an original with its face up on the original tray of the RADF, select
[2 Sided -> 2 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the inclination of the copy image.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
SETTING / ADJUSTMENT OF OPTION
Fig. 28-100 Chart (Original)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
28 - 48