Jam Code; Jam Codes (Main Body); Jam Codes (Adf) - Canon LASER CLASS 810 Service Manual

Chapter 15
Display Detail Code
Code
E733 0000
E736 0000
E739 0000
E805 0000
E808 0000

15.2 Jam Code

15.2.1 Jam Codes (Main body)

Code Name
0104 Pickup Delay Jam
0208 Pickup Stationary Jam
010c Delivery Sensor Delay Jam
0210 Delivery Sensor Stationary
Jam
0214 Stationary jam in machine
021c Wound Paper Jam at Fuser
1118 Door open jam

15.2.2 Jam Codes (ADF)

15-2
Main Cause/Symptom
Erroneous communication between controller and printer
Cannot communicate with the printer at startup.
CCU communication error
The installed modem PCB is incompatible.
Erroneous communication between controller and network board
The installed network board is incompatible.
Fan failure
The fan is faulty.
Fixing drive circuit failure
- The heater does not turn on.
- A fixing drive motor failure was detected.
Sensor No.
SR11 After execution of a pickup retry, the registration sensor (SR11) does not detect the leading edge of
paper within a specific period of time. Or after the duplex drive solenoid (SL1) is on, the registration
sensor (SR11) does not detect the leading edge of paper within a specific period of time.
SR11 After the registration sensor (SR11) has detected the leading edge of paper, the registration sensor
(SR11) does not detect the trailing edge of paper within a specific period of time.
SR5 After the registration sensor (SR11) has detected the leading edge of paper, the delivery sensor
(SR5) does not detect the leading edge of paper within a specific period of time.
SR5 - The delivery sensor cannot detect absence of paper within the specified time after turning off of
the registration clutch.
- The delivery sensor cannot detect absence of paper within the specified time after the sensor
detected the leading edge of paper.
SR5, SR9 After the registration sensor (SR11) has detected the trailing edge of paper, the delivery sensor
(SR5) does not detect the trailing edge of paper within a specific period of time.
SR5, SR11 The delivery sensor (SR5) has detected absence of paper within the prescribed time after it detected
presence of paper.
SR5, SR9, SR11, The door was opened when there was printing paper in the transport path.
SW2
Countermeasure
- Check the connectors of the DC controller PCB and image
processor PCB for normal connection.
- Check the power supply of the printer (Check whether
initialization is performed at startup).
- Replace the DC controller PCB or image processor PCB.
- Check the connectors of the image processor PCB and modem.
- Replace the modem PCB.
- Replace the image processor PCB.
- Check the connectors of the image processor PCB and network
PCB for normal connection.
- Replace the network PCB.
- Replace the image processor PCB.
- Check the fan connector.
- Replace the fan.
- Replace the DC controller PCB.
- Check the connector of the fixing film unit.
- Replace the fixing film unit.
- Replace the fixing drive motor.
- Replace the DC controller PCB.
- Replace the power supply PCB.
T-15-2
Description
0016-7825
0016-7826