McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 89

6. Click the drop-down arrow and select the appropriate IP
interface provider and then click Next>.
NOTE: Use I/O port 3 for all 1x1 configurations. When configuring a 2x2, use
I/O port 3 to connect the first circuit and I/O port 4 for the second circuit.
The IP Circuit Wizard Node10 Configure Interface dialog box
appears.
This dialog box enables you to configure the IP WAN interface
properties for Node10.
7. Enter the IP Address (IP WAN address) and the Subnet Mask.
Configuring an E_Port Extension over an Ethernet WAN
Configuring a 1x1 Ethernet Wide Area Network
drop-down arrow
5
5-13