McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 5

Adding an IP Circuit .............................................................. 6-12
Creating Data Paths for Fibre Channel Switch Interfaces. 6-21
Delivering the Configured Network ........................................... 6-26
Setting the Delivery Properties ............................................. 6-27
Delivery Wizard ...................................................................... 6-27
Deliver Network ..................................................................... 6-30
Viewing Logs ........................................................................... 6-30
Chapter 7 Configuring an E_Port Extension over an ATM WAN
Configuring a 1x1 ATM Wide Area Network .............................. 7-1
Gathering the IP Addresses..................................................... 7-2
Starting UltraNet ConfigManager.......................................... 7-3
Adding Nodes for an ATM WAN Configuration................. 7-3
Setting the Initial Configuration ............................................. 7-6
Setting the License Information .............................................. 7-9
Adding an ATM Circuit ......................................................... 7-11
Creating a Data Path............................................................... 7-24
Delivering the Configured Network ........................................... 7-30
Setting the Delivery Properties ............................................. 7-30
Delivery Wizard ...................................................................... 7-31
Deliver Network ..................................................................... 7-33
Viewing Logs ........................................................................... 7-34
Chapter 8 Configuring FICON Extension
Configuring a 1x1 Ethernet Wide Area Network ........................ 8-1
Gathering the IP Addresses..................................................... 8-2
Starting UltraNet ConfigManager.......................................... 8-3
Adding Nodes for an Ethernet WAN Configuration........... 8-4
Adding a Fibre Channel Interface .......................................... 8-5
Setting the Initial Configuration ............................................. 8-7
Setting the License Information ............................................ 8-10
Adding an IP Circuit .............................................................. 8-12
Creating a FICON Data Path................................................. 8-20
Using the FICON Global Settings Wizard........................... 8-24
Delivering the Configured Network ........................................... 8-31
Setting the Delivery Properties ............................................. 8-31
Delivery Wizard ...................................................................... 8-32
Deliver Network ..................................................................... 8-34
Viewing Logs ........................................................................... 8-35
Contents
v