Configuring a 1x1 Ethernet Wide Area Network
5
McDATA UltraNet Edge 3000 User Guide
5-4
NOTE: If you are configuring a 2x2, the Ethernet Maintenance Interface and
both WAN interfaces must be on separate subnets.
1. Select the Nodes tab located on the toolbar between the TreeView
Area and the Network Map Area (see Figure 5-2 on page -3).
The Nodes tab displays three drop-down menus, containing the
node types for each available UltraNet Edge Series.
2. Click the arrow next to the UltraNet Edge 3000 Series drop-down
menu and select the Edge3000 (1x1 - 1 Gbps Ethernet) node type.
3. Click in the Network Map to create an instance of the UltraNet
Edge 3000 node.