McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 349

NOTE: Using a screw longer than 1/4 inch will impinge on the power supply
and make it impossible to remove.
2. Position the UltraNet Edge 3000 unit in the rack. It may be
Approximately
6"
10-32 Screws
3. Using a #2 Phillips screwdriver and four screws (two for each
— For a recessed mount, position the brackets so they are
extended from the front of the UltraNet Edge 3000 unit
approximately 3 1/4". Attach the brackets using the rear holes
(see illustration below).
necessary to tilt the unit approximately six inches or so to clear
the rack mounting rails (a 4U opening is needed to accomplish
this).
bracket) designed for the rack, attach the UltraNet Edge 3000 with
the bracket ears to the equipment rack.
UltraNet Edge 3000 Placement
6-32 Flathead Undercut Screws (8)
Bracket Ear (2)
Equipment Rack
Mounting Rails
B-3