Ultranet Webview Monitoring Application - McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual

UltraNet WebView Monitoring Application

5. Issue the
tartoc <filename>
the files within the tar archive file you wish to extract.
6. Check the resulting list to see if any of the files within the tar
archive already exist on the disk. If versions of the files within the
tar archive already exist on the disk, check their size to see if they
are larger than the versions in the tar archive.
7. If any files in the tar archive are larger than the corresponding
files on the disk, proceed to step . If the files in the tar archive are
smaller than the corresponding files on the disk, do one of the
following:
— Rename the corresponding file(s) on the disk using the
<file 1><file 2>
— Remove the corresponding file(s) on the disk using the
remove <file>
8. Issue the
tarExtract "vx_tar.tar",0
prompt. Wait for the prom prompt to return before proceeding to
step .
9. After the
tarExtract
command to boot up the UltraNet Edge 3000.
10. Remove any files that were renamed in step .
11. Issue the
flash_html "romx"
12. Issue the command after the
reset
complete.
UltraNet WebView is McDATA's browser-based monitoring tool for
the UltraNet product family. It provides the ability to monitor SNMP
interface statistics and the status of the chassis on an individual node
in an UltraNet storage network. UltraNet WebView provides
McDATA node monitoring capabilities from any location in the
world that has an internet connection plus security access to that
node. It supports browser-based access to Java applications through
an Ethernet maintenance interface and in-band browsing through a
WAN port.
UltraNet WebView Monitoring Application
command to display a listing of
command.
command.
command at the prom
command is complete, issue a
command at the prom prompt.
flash_html "romx"
Product Support and Software Maintenance
11
rename
reset
is
11-11