McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 249

This option, referred to as the Report LUNs mode, determines
how LUN 0 is represented on this interface. It is used by initiators
to determine the LUN inventory of certain devices (typically
RAIDs). The Report LUNs command is processed locally and
reflects all configured or discovered devices.
Emulate — LUN 0 is statically configured as a local McDATA
controller. This mode results in the Report LUNs
command being intercepted and an inventory being
generated based on the UltraNet configuration.
When this occurs, the initiator will follow up with the
INQUIRY commands to all the devices included in
the UltraNet configuration. Results of Emulate mode
will vary depending upon the behavior of the
initiator to the emulated inventory. This mode will
not work for all configurations.
Passthru — LUN 0 is an actual remote device (either discovered
or configured). This mode allows the Report LUNs
command and response to flow through the
McDATA network unaltered. Only the LUNs in the
Report LUNs reply will be known to the initiator.
Emulate mode is the default.
14. Click on the Host tab.
15. Enter the source WWN in the Source WWN field for each LUN
that needs filtering applied.
See the example shown in Figure 8-3 and Table 8-2 (page -5) for
the source of this WWN.
Configuring Tape Device Extension
Configuring Tape Device Extension
9
9-41