Table of Contents
Advertisement
Overview
This appendix provides installation and cabling information for the
UltraNet Edge 3000.
The UltraNet Edge 3000 host and network I/O hardware components
have been pre-installed. You are responsible for the following:
•
Review the site-preparation requirements in
Preparation
before installing the UltraNet Edge 3000 hardware.
•
Decide on unit placement.
•
Unpack and inspect the UltraNet Edge 3000 unit.
•
Take an inventory of UltraNet Edge 3000 components.
•
Ensure that ESD procedures are followed, see "Cables and
Equipment" on page -14.
•
If the UltraNet Edge 3000 is placed in a rack mount, attach
mounting brackets to the front corners of the unit.
•
Mount UltraNet Edge 3000 on the equipment rack (or place in
tabletop position).
•
Acquire and attach the appropriate cable types and lengths.
NOTE: After hardware installation is complete, use the UltraNet
ConfigManager configuration application to perform your network
configurations.
Installation and Cabling
Appendix A, Site
B
B-1
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the ULTRANETTM EDGE STORAGE ROUTER 3000 and is the answer not in the manual?
Questions and answers