McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 152

Configuring a 1x1 ATM Wide Area Network
7
McDATA UltraNet Edge 3000 User Guide
7-14
8. Configure the PVC parameters for Node10 by entering the
appropriate information in the following fields:
NOTE: If POS (Packet over SONET) is enabled, it is not necessary to enter
values in the Virtual Path ID (VPI) and Virtual Channel ID (VCI) fields, they
are not used for this protocol.
a. Enter the Virtual Path ID (VPI). The value that can be entered
in this field is determined by the Active VCI Bits value.
Initially the Active VCI Bits Value is set to 11, only 0 and 1 are
valid enabled VPI values. The default setting is 0.
Active VCI Bits Value
12
11
10
4
b. Enter the Virtual Channel ID (VCI). The value that can be
entered in this field is determined by the Active VCI Bits
value. Initially the Active VCI Bits value is set to 11, valid
Valid Enabled VPI Values
Zero
Zero and 1
Zero through 3
Zero through 255