McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 83

The Initial Network Setup dialog box appears. The detected
UltraNet Edge 3000 will appear in the section labeled RECEIVED
UltraNet Configuration Requests.
Broadcast Data
The "broadcast data" only appears the first time you configure,
when the Alphanumeric messages window displays BOTP on
the front of the UltraNet Edge 3000.
2. Click on the line of text (the Broadcast Data) that appears in that
section to cause the serial number and MAC Address fields to
appear.
3. Modify the Assign IP Address, the Assign Netmask address, and
the Assign Gateway address in the middle of the dialog box to
the maintenance interface and default gateway addresses.
NOTE: If you are using the Configuration IP Address Worksheet, enter the
following information:
For Node10, enter the IP address labeled
.
For Node20, enter the IP address labeled
.
Configuring a 1x1 Ethernet Wide Area Network
Configuring an E_Port Extension over an Ethernet WAN
and the gateway address labeled
and the gateway address labeled
5
5-7