Fibre Channel Interface Card Installation Procedure - McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual

Fibre Channel Interface Card Installation Procedure

12
Fibre Channel Interface Card Installation Procedure
McDATA UltraNet Edge 3000 User Guide
12-10
5. Remove the two screws at the rear of the Fibre Channel interface
card.
6. Carefully pull the Fibre Channel interface card up. It is connected
to two socketed connectors.
7. Remove the Fibre Channel interface card from the chassis.
8. Follow the Fibre Channel Interface Card Installation Procedure to
install a new Fibre Channel interface card.
Fibre Channel
Interface Card
(1 Gigabit or 2 Gigabit)
I/O 4
I/O 3
Use the following procedure to install the Fibre Channel (FCBB)
interface card into the UltraNet Edge 3000 chassis.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15 in-lbs.
CAUTION
Make sure the power is off. Attach a wrist strap and follow ESD
procedures during the handling of all electronic components.
1. Carefully insert the Fibre Channel interface card in either I/O 1 or
I/O 2.
Screw (2)
I/O 2
I/O 1