McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 163

2. Click the Create Data Paths selection. You should see "marching
ants" outlining the FC/IP interface.
3. Double-click on the destination FC/IP interface (the cloud icon
for Node20) in the network map.
The Create Data Path Wizard - Introduction dialog box appears.
4. Click Next.
The Create Data Path Wizard - Choose Network Routing
Option dialog box is displayed.
Configuring an E_Port Extension over an ATM WAN
Configuring a 1x1 ATM Wide Area Network
7
7-25